Siemens SINUMERIK 840C - Manual (Page 113)

ACTIVATE
OPTIONS
09.95

Siemens AG 2001 All Rights Reserved 6FC5197– j AA50 4–50
SINUMERIK 840C (IA)
Press the select key to select.
Press the ACTIVATE OPTIONS key for activating the selected option.
Notes The options Graphic Programming System Turning/Milling, DIN simulation, PG
software and special languages cannot be activated via the menu Start-up/Op-
tions.
This installation is always performed via menu item “Install MMC system” in the
BACK-UP menu (see Section 4.6, BACKUP with Valitek streamer).
If the system software is updated all of the above mentioned software options
must be reinstalled from magnetic tape.
4.6 BACKUP with Valitek streamer/PC link
The function BACKUP backs up all the data on the hard disk using a VALITEK
streamer/PC link, i.e. the system software (SIEMENS), the user software (e.g.
customer UMS), part programs and machine data are all stored on a magnetic
tape cartridge or external PC.
Up to SW 1 it is not possible to store any user data using the VALITEK streamer
(hardware option). With SW 2 and higher user data can be stored separately.
It is necessary to perform a BACKUP after every start-up, otherwise all data
would be lost if there were a fault on the MMC CPU! The choice of VALITEK
streamer or PC link can be made via the menu Set I/O device.
Caution!
The software for the BACKUP function is suitable for use
with the VALITEK streamer or PC link.
Caution! For Valitek streamers only!
Save system data and user data on separate cartridges
since backup overwrites any data already existing on the
cartridge.
Installation of the VALITEK streamer:
The VALITEK streamer can only be connected to the parallel interface (CEN-
TRONICS interface) of the MMC CPU with Siemens cable 6FC9 344–4X
V . It is
not possible to connect another streamer because the software is only suitable
for the VALITEK streamer.
If you connect to the interface SERIAL1 or SERIAL2 in-
stead of the interface PARALLEL1, you will destroy the
MMC CPU!
4 MMC Area Diagnosis
4.5 Activating options (as from SW3)
01.99