Siemens SINUMERIK 840C - Manual (Page 387)

6 NC Machine Data (NC MD), NC Setting Data (NC SD) 09.95
6.9 MDs for parameter set switchover
Number of teeth motor 2) 1st par. set to 8th par. set
3032*-
3060*
Default value Lower input limit Upper input limit Units
1 1
999 999
99 999 999 (as from SW 4.4)
–
Active on
Power On
Number of teeth spindle 2) 1st par. set to 8th par. set
3064*-
3092*
Default value Lower input limit Upper input limit Units
1 1
999 999
99 999 999 (as from SW 4.4)
–
Active on
Power On
This machine data is used to define the speed ratio of a gear box for all parameter sets, see
functional description of "”Ratio” parameter group".
Zero mark correction + 2) 1st par. set to 8th par. set
3096*-
3124*
Default value Lower input limit Upper input limit Units
0
- 999 999
16 000 (as from SW 4.4)
999 999
16 000 (as from SW 4.4)
units (MS)
Active on
NC Stop
Zero mark correction - 2) 1st par. set to 8th par. set
3128*-
3156*
Default value Lower input limit Upper input limit Units
0
- 999 999
16 000 (as from SW 4.4)
999 999
16 000 (as from SW 4.4)
units (MS)
Active on
NC Stop
These MDs are used to correct gear-stage-related offsets between the zero mark and
reference position, see functional description of "”Ratio” parameter group".
Backlash comp. 1st measuring system 2) 2nd par. set to
8th par. set
3160*-
3184*
Default value Lower input limit Upper input limit Units
0 - 16 000 16 000 units (MS)
Active on
NC Stop
For axes only:
To compensate for the backlash in different gear stages.
Motor control equilibration 2nd - 8th par. set
as from SW 4
3188*-
3212*
Default value Lower input limit Upper input limit Units
0
-70
-700 (as from SW 4.4)
70
-700 (as from SW 4.4)
0.1 % of the power
section current
Active on
NC Stop
These MD have the same meaning as MD 1292*, see also ”Functional Descriptions:
Parameter set switchover”.
_______
1) As from SW 4.4
2) As from SW 4
6–202 © Siemens AG 1992 All Rights Reserved 6FC5197- AA50
SINUMERIK 840C (IA)