2 adding a 1-axis fdd module (as from sw 3) – Siemens SINUMERIK 840C User Manual
Page 172
09.95
Siemens AG 2001
All Rights Reserved
6FC5197–
j
AA50
5–44
SINUMERIK 840C (IA)
5.9.2
Adding a 1-axis FDD module (as from SW 3)
Specifications
Module slots:
Slot 1:
MSD module
(Installation location) Slot 2:
free
Slot 3:
free
Slot 4:
2 axis FDD module
Slot 6:
1 axis FDD module
Entering the
Enter the additional 1 axis FDD module for slot 2 (installation location) in the
drive configuration
drive configuration display. Select the actual module type with Select module
softkey. Confirm these settings with the Accept Conf + NCKP0 softkey.
Fig. 5.18
Motor selection
Select the actual motor type with the Enter motor softkey. Confirm this setting
with the Accept all + NCKP0 softkey.
Notes
Please make sure that you enter NC MD 3840 and 2000 correctly (assign).
The drive numbers of drives already installed must not be changed, i.e. a new
drive must be given a new drive number.
5 Machine Data Dialog (MDD – as from SW 3)
5.9.2 Adding a 1-axis FDD module (as from SW 3)