Siemens SINUMERIK 840C - Manual (Page 271)

6 NC Machine Data (NC MD), NC Setting Data (NC SD) 04.96
6.6.1 General MD bits (general bits)
7 6 5 4 3 2 1 0
Bit No.
NC MD
5002
Input resolution
Possible combinations
See table for MD 18 000
Default value: 01000000
For combinations with display resolution (NC MD 1800*) and position control resolution
(NC MD 1800*).
Active on: NCK Power On
The input resolution (IS) defines the incremental weighting for entering and displaying values.
At the same time the initial setting G70 (inches) or G71 (mm) is defined.
Bit 7 6 5 4
mm/
degrees
-- -- -- --
10 -1
1 0 0 0 10 -2
0 1 0 0 10 -3
0 0 1 0 10 -4
1 0 1 0 10 -5
-- -- -- --
10 -6
metric
Bit 7 6 5 4
inch/
degrees
-- -- -- --
10 -1
-- -- -- --
10 -2
0 1 0 1 10 -3
1 1 0 1 10 -4
1 0 1 1 10 -5
0 1 1 1 10 -6
MD 5002, Input resolution
All linear axes and rotary axes of the control can be defined with an axis-specific position
control and display resolution. The input resolution and the resulting geometrical resolution
(used for programming, TO, ZO, interpolation...) is defined once for the whole control (detail
description see Section entitled ”Axis (Analog) and Spindle Installation”).
With these axis-specific resolutions (detailed description see Section entitled ”Axis (Analog)
and Spindle Installation”) the demands of the machine regarding
•
maximum velocity
• varying precision
• maximum traversing range
can be optimally met.
Input resolution NC MD 5002 bit 4 to 7
Axis-specific display resolution NC MD 1800* bit 4 to 7
Axis-specific position control resolution NC MD 1800* bit 0 to 3
6–86 © Siemens AG 1992 All Rights Reserved 6FC5197- AA50
SINUMERIK 840C (IA)