Siemens SINUMERIK 840C - Manual (Page 89)

09.95

Siemens AG 2001 All Rights Reserved 6FC5197– j AA50 4–26
SINUMERIK 840C (IA)
4.4.2.1 Keywords
Keywords are words reserved by the system.
The following keywords exist:
S
LANGUAGE Language set for NCK and MMC
S
LANGUAGE1 Language set for WOP 3)
S
LANGUAGE2 Language set for simulation 3)
S
LANGUAGE3 Language set for PG function 3)
S
LANGUAGE4 Language set for user 3)
S
BT_NAME FlexOS name of the operator panel interface
S
BT_PARAM Name “”; operation without operator panel
S
PROTLEN1 Size of the alarm log in number of messages
S
PROTLEN2 Size of the service log in number of messages
S
FLUSHLEN1 Maximum number of messages buffered for the alarm log
S
FLUSHLEN 2 Maximum number of messages buffered for the service log
S
FLUSHTIME Maximum buffering time for messages in milliseconds
S
PROTMASK1 Type of messages to be entered in the alarm log 1)
S
PROTMASK2 Type of messages to be entered in the service log
S
PRIO_PO Display priority of NCK alarms with alarm type “power on” 1)
S
PRIO_RE Display priority of NCK alarms with alarm type “reset” 1)
S
PRIO_CA Display priority of NCK alarms with alarm type “cancel” 1)
S
PRIO_PA Display priority of PLC alarms 1)
S
PRIO_PM Display priority of PLC messages 1)
S
PRIO_KO Display priority of NCK comments 1)
S
SYSFONT Defines the character set in the configuration file of the
master control
2)
S
TFORMAT Format in which the times are to be written to the log
4 MMC Area Diagnosis
4.4.2 Configuration file CONFIG
1) Up to SW 2 only
2) SW 4.4 and higher
3) SW 5 and higher