Siemens SINUMERIK 840C - Manual (Page 1139)

12 Functional Descriptions 01.99
12.36.7 Error handling
The entry XXX in the log file is the name of the target file i.e. the name of the destination data
block.
Check of the last line
for errors
12.36.8 Configurability of the conversion
The user can control the conversion via the ASCII lists. There is a central configuration file
(CONFIG) and a common list of descriptions file (LIST) for all groups (TEA1, TEA2, TEA4).
The selection of the configuration file and the list of descriptions is carried out via the softkeys
Diagnosis, PC data, Conversion data.
Fig.: Configuration file (CONFIG)
The line ”FILES=” is written by the internal conversion routine i.e. the name of the source file
and the name of the target file are recorded there. These files are required for the switchover.
12–364 © Siemens AG 1992 All Rights Reserved 6FC5197- AA50
SINUMERIK 840C (IA)