Siemens SINUMERIK 840C - Manual (Page 505)

7 Drive Machine Data (SIMODRIVE Drive MD) 07.97
7.3.2 Drive MD (data description)
Number of pole pairs motor 1112
Default value Lower input limit Upper input limit Units
0 0 4 –
Active on
Power On
Input of number of pole pairs of motor as specified on the motor data sheet (also non-Siemens
motor) or through automatic parameterization using machine data "Motor code number"
(MD 1102). The pole pair number 0 is entered when motor/power section combinations which
have not been enabled are loaded.
Note:
This data is relevant only for FDD drives.
Pole pair number limit
MSD
Linear motor
CD track
Encoder marks
> 2048
Encoder marks
< 2049
4 16 6 64 16
Rotating motor
FDD
Hall sensor etc.
If these limits are exceeded, the drive outputs an error message.
Torque constant 1113
Default value Lower input limit Upper input limit Units
0.0 0.0 300.0 (as from SW 6) Nm/A
Active on
Power On
Input of torque constant as specified on the motor data sheet (non-Siemens motor) or
automatic parameterization using machine data "Motor code number" (MD 1102). The torque
constant is the quotient of rated torque : rated current (RMS) for permanent-field synchronous
motors.
Note:
This data is relevant only for FDD drives.
Voltage constant 1114
Default value Lower input limit Upper input limit Units
0.0 0.0 300.0 V
Active on
Power On
Input of voltage constant as specified on the motor data sheet (non-Siemens motor) or
automatic parameterization using machine data "Motor code number" (MD 1102).
The voltage constant is measured as an induced voltage (EMF) under no-load conditions at
n = 1000 rev/min as the RMS value of the motor terminals (line-to-line).
Note:
This data is relevant only for FDD drives.
7–90 © Siemens AG 1992 All Rights Reserved 6FC5197- AA50
SINUMERIK 840C (IA)