Siemens SINUMERIK 840C User Manual
Page 117
2
1
2
3
1
2
3
4
4
1
2
3
5
6
3
4
5
6
09.95
Siemens AG 2001
All Rights Reserved
6FC5197–
j
AA50
4–54
SINUMERIK 840C (IA)
Setup / Configure options
Setup WOP options
See Configuring Guide Graphic Programming System
Create WOP working file
Service function for creating a new WOP working file
Set I/O device
Valitek PST–160
Valitek PST2 – M1200
Valitek PST2 – M1200 to read PST–160 tapes
PC link
Set disk check
Settings for checking the consistency of the file system on the hard disk (similar to the
DOS command CHKDSK).
Set new configuration
To set the intervals at which the check file system procedure is to be per-
formed when the control is booted.
Reset to default configuration
Restore default setting, i.e. file check every 24 hours.
Return to previous menu
Adjust display (as from SW 5.6, for service only)
Return to previous menu
DR DOS shell
For service task only (password protected)
MMC system check (SERVICE mode)
Check sum of all the system software installed on the hard disk
OEM
For more detailed information please refer to the OEM documentation.
End (load MMC)
Starts the MMC
4 MMC Area Diagnosis
4.6 BACKUP with Valitek streamer/PC link
01.99