Siemens SINUMERIK 840C - Manual (Page 30)

1 Prerequisites and Visual Inspection 03.95
1.5.1 Self-test and system start-up
File system check (SOFTWARE 4.4 and higher)
Messages during the file system check:
The previous message
Checking file system COMPLETE
is replaced by the following:
• During the file system check:
Verifying file system: Pass 1 COMPLETE
Verifying file system: Pass 2 COMPLETE
Verifying file system: Pass 3 COMPLETE
• If the WOP work file has to be recreated, the following message also appears:
Creating WOP working file ...
The following messages are output if an error occurs:
• If the file system cannot be restored
ERROR in file system: can't fix
• If the WOP work file cannot be created:
ERROR on WOP working file: can't create
After these error messages, the previous message
Can't start MMC - REBOOTING
appears.
Then the system branches to DOS.
Selection menu "SETUP/CONFIGURE OPTIONS"
The following entry has been added to the menu (so that the WOP working file can also be
created via menu):
Create WOP working file
The menu is now structured as follows:
Please select:
1 Setup WOP option
2 Create WOP working file
3 Set streamer type
4 Setup disk check
5 Return to main menu
Enter a number [1-5]:
1–10 © Siemens AG 1992 All Rights Reserved 6FC5197- AA50
SINUMERIK 840C (IA)