Siemens SINUMERIK 840C - Manual (Page 414)

01.99 6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.12.1 NC setting data (NC SD)
Axis converter setting data
7 6 5 4 3 2 1 0
Bit No.
SD
626*
to
699*
Axis converter
The setting data are stored in binary format as follows.
SD 626* 1st programmed axis channel-
specific SD 628* 1st machine axis channel-
specific
SD 630*
.
.
.
2nd programmed axis channel-
specific SD 632*
.
.
.
2nd machine axis channel-
specific
Setting data software cam
7 6 5 4 3 2 1 0
Bit No.
SD
7000
to
7007
Software cams
The cam positions refer to machine zero and are used in the active machine dimension
system (metric or inch). No check is made that the set cam position is within the maximum
positional values (maximum traversing range).
The setting data for the cam positions can be read or written using the @ functions.
The setting data are stored in binary format as follows:
SD 7000* Minus cam of cam pair 1 SD 7002* Minus cam of cam pair 2
SD 7001* Plus cam of cam pair 1 SD 7003* Plus cam of cam pair 2
SD 7004* Minus cam of cam pair 3 SD 7006* Minus cam of cam pair 4
SD 7005* Plus cam of cam pair 3 SD 7007* Plus cam of cam pair 4
© Siemens AG 1992 All Rights Reserved 6FC5197- AA50 6–229
SINUMERIK 840C (IA)