Siemens SINUMERIK 840C - Manual (Page 444)

10.94 7 Drive Machine Data (SIMODRIVE Drive MD)
7.1.2 MSD MD (data description - SW 3)
Address for stop condition 210
Default value Lower input limit Upper input limit Units
0000 0000 FFFF Hex
Active
at once
Input of address for the variable which is significant for stopping the recording (see also
MD 206).
Threshold for stop condition 211
Default value Lower input limit Upper input limit Units
0000 0000 FFFF Hex
Active
at once
Input of threshold (value) with which the contents of the variable specified in MD 210 are
compared in order to stop the recording (see also MD 206).
Address for signal 1 212
Default value Lower input limit Upper input limit Units
0C00 0000 FFFF Hex
Active
at once
Input of address of recording signal 1 (see also MD 206).
Address for signal 2 213
Default value Lower input limit Upper input limit Units
0C04 0000 FFFF Hex
Active
at once
Input of address of recording signal 2 (see also MD 206).
Start output of recording 214
Default value Lower input limit Upper input limit Units
0000 0000 0001 Hex
Active
at once
Input of start for the output of the transient recorder function (see also MD 206).
The contents of the recorder memory are output via 2 DACs as soon as the above machine
data is set to 1H. The output is repeated cyclically.
Shift factor signal 1 215
Default value Lower input limit Upper input limit Units
0 0 15 –
Active
at once
Input of shift factor for signal 1 (see also MD 206). The top 8 bits from a 16-bit wide memory
location are output. This machine data specifies how often the value must be shifted to the left
beforehand.
© Siemens AG 1992 All Rights Reserved 6FC5197- AA50 7–29
SINUMERIK 840C (IA)