Siemens SINUMERIK 840C - Manual (Page 772)

01.99 11 Data Backup/CPU Replacement
11.1.7 Loading from hard disk (control startup with user data)
Boot file generated
Loading drive user data TEA3
Warning:
Digital drives must be switched in!
39) SK ”Exit general reset mode”
40) SK ”Machine data”
41) SK ”Drive MD”
42) SK ”File functions”
43) Place cursor on required file
44) SK ”Loading from disk”
45) Set ”Config.” area
via toggle switch
46) SK ”Loading start”
47) After completion of loading,
press ”Recall”
48) Vertical SK
Accept ”Conf” + ”NCK PO”
49) Machine display faded in
50) Press area switchover key
51) SK ”Diagnosis”
52) SK ”File function”
53) Place cursor on required file
!!!Data transfer from PC to NC in progress!!!
3
© Siemens AG 1992 All Rights Reserved 6FC5197- AA50 11–13
SINUMERIK 840C (IA)