Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1000)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
984 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Identification Description
.PK{#}.ABS Absorbance of the peak with the greatest absorbance
(maximum absorbance) for evaluation # (1…9)
.PK{#}.TRN Transmission of the peak with the greatest absorbance
(minimum transmission) for evaluation # (1…9) in %
.PK{#}.CNT Intensity of the peak with the greatest absorbance
(maximum intensity) for evaluation # (1…9)
.PK{#}.CNR Intensity in reference spectrum 'Command
name'.PK{#}.WVL for evaluation # (1…9)
.PK{#}.CND Intensity in dark spectrum 'Command
name'.PK{#}.WVL for evaluation # (1…9)
.PK{#}.WVL Wavelength of the peak with the greatest absorbance
for evaluation # (1...9) of the discovered maximum
.PK{#}.SAT Specification as to whether the dectector was satura-
ted with 'Command name'.PK{#}.WVL for evaluation #
(1…9)
5.6.4.13.2 MEAS Spec - General/Hardware
Tab: Method ▶ MEAS Spec ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the device
type belonging to the selected device is displayed instead