Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1214)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1198 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Start delay
Waiting time in seconds or minutes before the initiated action is started.
Range 0 ... 999999
Default value 0
Selection s | min
Default value s
Working time
The time for which the digital output can be set to ACTIVATED can be
specified in seconds or minutes when Action = Timer. It is reset to DEAC-
TIVATED after the working time has expired.
Range 0.01 ... 999999
Default value 0
Selection s | min
Default value s
End delay
Waiting time after the working time has expired
Range 0 ... 999999
Default value 0
Selection s | min
Default value s
Parameters
Parameter 1
The meaning of Parameter 1 depends on the Type of the digital output that
has been set.
When Type = Stirrer: stirrer output in %, pulse duration dependent on
Parameter 2.
Range -214783647 ... 214783647
Default value 100
Parameter 2
The meaning of Parameter 2 depends on the Type of the digital output that
has been set.
For Type = Stirrer:
￭ 0: Duration of the switch-on pulse fixed at 500 ms.