Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 56)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
40 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Identifica-
tion Description Commands
.LP.MEA Measured value for the last meas-
uring point of the measuring point
list in the unit of the measured value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL
MEAS, DOS
.LP.QTY Measured value (water) for the last
measuring point in the measuring
point list in µg KFC, BRC
.LP.TEM Temperature for the last measuring
point of the measuring point list in
°C DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL
MEAS, DOS
.LP.TIM Time in s until the last measuring
point in the measuring point list is
reached DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL
MEAS, DOS
.LP.TRN Transmission of the last measuring
point of the measuring point list in
% MEAS Opt
.LP.UGE Voltage at the generator electrode
for last measuring point of the
measuring point list in V; in case of
measurements with 756, 831: 0 =
not defined, 1 = <14 V, 2 = 14…
28 V, 3 = >28 V KFC, BRC
.LP.VOL Volume for the last measuring point
in the measuring point list in mL DET, MET, SET,
KFT, STAT, DOS
.LPO Current absolute lift position in mm
(entry when ending the command) LIFT
.LST Start time of the loop command
(Date/Time) LOOP, CAL LOOP
.MA.CNT Intensity for maximum measured
value in counts MEAS Opt