Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1003)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 987
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS Opt are configured on the fol-
lowing 3 tabs:
￭ General/Hardware
Parameters for device.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluations
Definition of evaluation results for absorbance measurements.
Command variables
The following command variables are generated in the method run by the
command MEAS Opt and can be used in formulas under the designation
'Command name.Variable designation':
Identification Description
.BP{#}.[MEA] Measured value for the break-point (1…9) in the unit
of the measured value
.BP{#}.CNT Intensity for the break-point x (1…9) in counts
.BP{#}.TEM Temperature for the break-point # (1…9) in °C
.BP{#}.TIM Time for the break-point # (1…9) in s
.BP{#}.TRN Transmission for the break-point x (1…9) in %
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has not ever been started
.DBL Total duration for the processing of the command in s
.EME Final measured value (measured value after processing
of the command) in the unit of the measured value
.FIN Command status; 1 = Command has been ended
at least once, 0, invalid (variable not available) =
Command has never been ended
.FP{#}.[MEA] Measured value for the fix endpoint # (1…9) in the unit
of the measured value