Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1330)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1314 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Order number
Order number of the sensor (read-only for intelligent sensors and the Ther-
moprobe).
Input 24 characters
Default value 'empty'
Sensor serial number
Serial number of the sensor (read-only for intelligent sensors and the Ther-
moprobe).
Input 10 characters
Default value 'empty'
Device
For non-intelligent sensors it is possible to select the device to which the
sensor is connected. All the devices in the device table which have a meas-
uring input are shown in the selection list. The connection of a sensor to a
particular device is not checked during the run. In the case of intelligent
sensors and the Thermoprobe, the device to which the sensor is connected
is shown here automatically.
Selection Selecting device | 'empty'
Default value 'empty'
Measuring input
For non-intelligent sensors it is possible to select here the measuring input
to which the sensor is connected. The connection of a sensor to a particular
measuring input is not checked during the run. This parameter only appears
if a Device has been chosen. For intelligent sensors and the Thermoprobe
the measuring input to which the sensor is connected is shown here auto-
matically.
Selection 1 | 2
Default value 1
Comment
It is possible to enter remarks about the sensor.
Input 24 characters
Default value 'empty'
Start-up
The current date is automatically entered here for a newly added sensor.
When editing an existing sensor, the date can be selected by pressing in
the dialog window Select date (see Chapter 2.5.1, page 83).