Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 146)

3.6 Subwindow Run ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
130 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Note
If a negative value is entered in this field (e. g. during data import from a
scale in the event of reweighing), then this will be also be calculated as a
negative in the formula editor.
Input Number with a maximum of 10 digits
Default value 1.0
Unit
Sample size unit (initial weight). There are no restrictions on the text to be
entered in this field.
Input 16 characters
Selection g | mg | µg | mL | µL | pieces
Default value g
Note
Generally speaking, no formula input is possible in these fields.
If the option Comment on modification of sample data (live) is ena-
bled in the security settings, then a reason and a comment on the
modification must be entered before saving (see Chapter 6.2.2.4, page
1238).
3.6.3.8 Single determination - Determination run
Tab: Workplace ▶ Run ▶ Single determination
A determination that is started on the tab Single determination in the
subwindow Run runs through as follows:
1 - Loading the sample data
The sample data entered for the determination is loaded.
2 - Method selection
The following actions are triggered with method selection:
￭ Method selection without Assignment ID
The method selected in the field Method is loaded.
￭ Method selection by assignment ID
If the option Method selection by assignment ID is enabled in the
properties of the single determination on the tab Process (see Chapter
3.6.3.9.4, page 135), then the method defined in the sample assignment
table will be loaded (see Chapter 3.4, page 118).