Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 530)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
514 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Lower limit
Value for the lower limit of the Gran evaluation range.
Range -2000.0 ... 2000.0 mV
Default value -2000.0 mV
Upper limit
Value for the upper limit of the Gran evaluation range.
Range -2000.0 ... 2000.0 mV
Default value 2000.0 mV
5.6.3.2.4.8 DET Ipol - Additional measured values
Tab: Method ▶ DET Ipol ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Input 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together in additional measured value columns
with the measured values present in the default settings:
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can be
calculated from existing measured values and saved, which can also be pre-
sented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Opens the dialog window Calc. measured value # in which the parame-
ters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 879).
[Properties]
Opens the dialog window Calc. measured value # in which the parame-
ters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 879).
[Delete]
Deletes the calculated measured value selected in the table.