Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 165)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 149
￭ Stop by error
If an error, which causes the determination to be interrupted, occurs, the
Error track (if present) is run through and the determination is stopped.
￭ Process exit track
if the main track and all tracks requested by the latter are ended, the Exit
track (if present) is run through and the determination is stopped.
￭ Process series end track
At the end of the last determination of a series, the series end track is
started. If [Stop] is pressed during running this track, the determination
is cancelled, if an error occurs, the Error track.
7 - Post-conditioning (only for methods with conditioning)
For methods containing commands with conditioning activated and for
which the option Automatic conditioning is activated in the START
command, the post-conditioning is automatically started for all these com-
mands with the method loaded and this immediately after the end of the
track containing the conditioning command. The status switches to COND
BUSY after the start of the post-conditioning. In this status the conditioning
can be cancelled with [Stop] or interrupted with [Hold] and continued with
[Cont]. If an error occurs during conditioning, neither the error track nor
the exit track are run through.
For methods containing commands with conditioning activated and for
which the option Automatic conditioning is activated in the START
command, the post-conditioning is automatically started for all these com-
mands with the method loaded and this immediately after the end of the
track containing the conditioning command.
￭ Condition requirement not fulfilled
The status switches to COND BUSY after the start of the post-condi-
tioning. In this status a new determination can be started with [Start]
although the condition requirement is not fulfilled. The conditioning can
aslo be cancelled with [Stop] or interrupted with [Hold] and continued
with [Cont]. If an error occurs during conditioning, neither the Error
track nor the Exit track are run through.
￭ Condition requirement fulfilled
If the conditioning requirement has been fulfilled, then the status will
switch to COND READY. A new determination can be started in this
status with [Start]. Conditioning can also be canceled with [Stop] or
interrupted with [Hold] and resumed with [Cont]. As long as the deter-
mination has not yet been started, the condition requirement will con-
tinue to be monitored on a continuous basis.