Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 834)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
818 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
855
Selection
1 | 2 | 3
Default value 2
Solution
Input of a solution name or selection of a solution from the solutions defined
in the solution table. If intelligent exchange or dosing units are used, then
a check will be made in the method run to see whether the correct solution
has been set on the selected dosing device and whether the dosing device
type is correct. With non-intelligent exchange or dosing units, only the cyl-
inder volume is checked.
Titrando, 855
Selection
'Solution name' | not defined
Default value not defined
not defined
No tests will be carried out.
Filling rate
Speed with which the dosing cylinder of the second dosing device is to be
refilled. The maximum filling rate depends on the cylinder volume of the
exchange unit or dosing device used. If the entered filling rate is too high
for the selected dosing device, it will automatically be reduced during dosing
to the largest possible value(see Chapter 5.6.3.8.5, page 811).
Titrando, 855
Range
0.01 ... 166.00 mL/min
Selection maximum
Default value maximum
Sensor
Measuring input
Selection of the measuring input to which the sensor is connected.
Titrando
Selection
1 | 2
Default value 1
855
Selection
1
Default value 1