Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1067)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1051
Sensor
Sensor
Selection of a conductivity sensor from the conductivity sensors available in
the sensor table.
Selection 'Sensor name' | Conductivity sensor
Default value Conductivity sensor
Temperature measurement
Type of temperature measurement.
856
Selection
continuous | automatic | off
Default value automatic
continuous
A temperature sensor must be connected. The temperature will then be
measured continuously.
automatic
If a temperature sensor is connected then the temperature will be meas-
ured continuously. Otherwise, the temperature entered manually under
Temperature on the Measuring parameters tab will be used.
off
The temperature will not be measured. The temperature manually
entered under Temperature on the Measuring parameters tab will
be used.
Stirrer
This section is visible only if the 856 Conductivity Module was selected as
device type.
Stirrer
Selection of the stirrer.
Selection 1 | 2 | 3 | 4 | off
Default value 1
off
Means that no stirrer will be used.
Stirring rate
Setting the stirring rate. The algebraic sign of the stirring rate changes the
direction in which the stirring is done.
Range -15 ... 15
Default value 8