Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 377)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 361
4.8 Subwindow curves
4.8.1 Curves - General
Dialog window: Database ▶ Curves
Subwindow curves
The subwindows Curves 1...5 are subwindows in the program part Data-
base, in which the measuring points generated by the measuring com-
mands for the focused determination in the Determination table are
shown as a graph. When navigating in the determination overview this data
will be updated automatically (with a certain delay).
The subwindows Curves 1...5 can be switched on in the program part
Database during the definition of the layout and thus made visible. They
can be enlarged and reduced as required; they can also be maximized.
Tabs
In the curve window a tab with the corresponding command name and the
run index (e.g. Chloride.1) is provided for each execution of a measuring
command; their sequence is determined by the method.
Show curves
The curves of the selected determination are shown on the tabs with the
properties defined per window and per command type. The command type
(e.g. DET pH) is shown above the left-hand y axis.
Curves can be zoomed as often as required by spanning a section of the
curve display with the left mouse button pressed down. Zooming can be
undone with a double-click on the section of the graph or with the context-
sensitive menu command Show All.
Note
When a new determination is selected the complete curve is always
shown, i.e. the zoom range is not retained when the determination is
changed.
Curves can be copied into the clipboard with the context-sensitive menu
command Copy graphics.
Show monitoring report
With the context-sensitive menu item Monitoring report... in the curve
window the dialog window Monitoring report - 'Command name'
opens for displaying the measuring point list with the selected curve.