Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 363)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 347
Message text:
Shows the message.
Message source:
Shows from where the message comes:
Selection Program | Track 'Track name' - Command
'Command name'
Program
Message that cannot be assigned to a particular command.
Track 'Track name' - Command 'Command name'
Message produced by a command during the run.
4.6.7 Information - Determination comment
Tab: Database ▶ Information ▶ Determination comment
Shows the comment on the determination.
Determination comment:
Shows the comment entered for the determination.
4.7 Subwindow Results
4.7.1 Results - General
Subwindow: Database ▶ Results
In the subwindow Results in the program part Database the results cal-
culated in the calculation commands and the variables used for are shown.
It shows the results overview, the raw data of the commands with evalua-
tions as well as the results calculated in the calculation commands, statistical
evaluations, formulas and all variables used for for the determination selec-
ted in the determination overview.
When navigating in the determination overview this data will be updated
automatically (with a certain delay).
The subwindow Results can be switched on and made visible in the defi-
nition of the layout in the program part Database. It can be enlarged and
reduced as required; it can also be maximized.
Tabs
The results of the determination are shown on the following tabs:
￭ Results overview
Shows the results overview for all calculation commands.
￭ Raw data
Display of evaluation raw data for commands with evaluations.