Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1345)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1329
for ISE (+1)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 62.4 mV
for ISE (-1)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -55.0 mV
for ISE (+2)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 32.7 mV
for ISE (-2)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -26.7 mV
for ISE (+3)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 22.7 mV
for ISE (-3)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -16.7 mV
for ISE (+4)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 17.8 mV
for ISE (-4)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -11.8 mV
Warning limits for pH(0) (only for pH electrodes)
on | off (Default value: off)
If this option is enabled, then the values for pH(0) will be shown in
orange if the limits are exceeded.
Lower limit
Lower warning limit for pH(0).
Range -2.147E+9 ... 2.147E+9
Default value 6,500
Upper limit
Upper warning limit for pH(0).