Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1051)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1035
Parameters
The parameters for the command CAL MEAS pH are configured on the
following 2 tabs:
￭ General/Hardware
Parameters for devices, sensors and stirrers.
￭ Measuring parameters
Parameters for setting the measurement procedure.
Command variables
The following command variables are generated in the method run by the
command CAL MEAS pH and can be used in formulas under the designa-
tion 'Command name.Variable designation':
Identifica-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.DBL Total duration for the processing of the command in s
.EME Final measured value (measured value after processing of
the command) in the unit of the measured value
.ETE End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
.IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.MEA Measured value for the last measuring point in the unit
of the measured value
.LP.TEM Temperature for the last measuring point of the measur-
ing point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached