Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1131)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1115
778, 789, 814, 815, 855, 864, 874
Selection
1 | 2 | 3
Default value 1
730, 774
Selection
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12
Default value 1
Solution
Input of a solution name or selection of a solution from the solutions defined
in the solution table. If intelligent dosing units are used, then a check will be
made in the method run to see whether the correct solution has been
attached to the selected dosing device. With non-intelligent dosing units,
only the cylinder volume is checked. At the start of the command, a check
is made of the working life, the validity of the titer and the GLP test interval
for the selected solution.
Input 24 characters
Selection 'Solution name' | not defined
Default value not defined
not defined
No tests will be carried out.
Note
For Dosing device and Solution exactly the same settings have to be
selected as for the dosing device reserved earlier by another command,
otherwise the dosing device is not being released.
Note
If the tandem dosing is used in a command (e.g. ADD), then both dosing
devices used have to be released each with a separate command RLS
DOS.
5.6.7 Automation commands
5.6.7.1 Automation commands - Overview
Menu item: Method ▶ Insert ▶ New command... ▶ Automation
Commands for the operation of Sample Processors.
The following eight automation commands can be selected: