Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1179)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1163
not defined
In this case, the device name must be assigned by the user at the start of
the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the device
type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types or
device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | Titrando
Default value Titrando
Remote Box
Selection of the Remote Box at which the lines are to be scanned.
Titrando, 856, 867, 814, 815, 855, 864, 874
Selection
1 | 2 | 3 | 4
Default value 1
Scan lines
Input signal
Input of the binary pattern for the expected input signal or selecting a pre-
defined signal pattern.
It is possible to enter the following characters:
0 = line inactive
1 = line active
* = any line status
Selection Bit-pattern with 8 characters (0, 1, *) | ********
| Signal pattern
Default value ********
The bits are numbered from right to left:
Input 7 6 5 4 3 2 1 0
Bit 7 6 5 4 3 2 1 0
Example:
*******1 expects an active input line 0 (1 = set). For example, this line is set
by a Titrino after a titration has been completed and the Titrino can accept
a start signal again.