Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 688)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
672 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Appearance
The command has the following appearance:
without conditioning with conditioning
Parameters
The parameters for the command SET U are configured in the following 8
tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titration.
￭ Control parameters
Control parameters for endpoint 1 and endpoint 2 (measured values for
the endpoints, titration rate, user defined parameters, stop criterion).
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Definitions of conditions which cause the stop of the titration.
￭ Conditioning
Enable/Disable the conditioning. Definition of the start drift, drift correc-
tion and stop conditions.
￭ Additional evaluations
Definition of additional methods for the evaluation of the titration curves.
￭ Additional measured values
Definition of additional measured values of other measuring commands
which are saved as additional columns in the measuring point list.
Command variables
The following command variables are generated in the method run by the
command SET U and can be used in formulas under the designation 'Com-
mand name.Variable designation':
Identification Description
.BLV Blank value of the sensor used for the command (only
for ISE sensors)
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started