Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 873)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 857
Stop command (Titrando, 855)
The running STAT command is quit, then the next command is executed.
Wait for [Continue]
Reagent dosing in the current STAT command is interrupted and a mes-
sage appears. As soon as the monitored measured value is again within
the limits (including hysteresis) reagent dosing can be resumed by press-
ing the [Continue] button in this message box.
Wait for limit ok
Reagent dosing in the current STAT command is interrupted. As soon
as the monitored measured value is again within the limits (including
hysteresis), reagent dosing will be resumed automatically.
none
No action will be taken if limits are exceeded.
Monitoring Temperature
Monitoring Temperature
on | off (Default value: off)
If this check box is activated, then the temperature will be monitored and
any exceeded limits will be entered in the measuring point list.
Lower limit
Lower limit of the temperature. When the temperature falls below this value,
the action Lower temperature limit exceeded is triggered.
Titrando, 855
Range
-20.0 ... 150.0 °C
Default value -20.0 °C
Titrino
Range
-170.0 ... 500.0 °C
Default value -170.0 °C
Lower hysteresis
Lower hysteresis of the temperature. When the temperature once again
exceeds the lower limit by this hysteresis value, the action Temperature
lower limit ok is triggered.
Titrando, 855
Range
0.0 ... 150.0 °C
Default value 0.2 °C
Upper limit
Upper limit of the temperature. When the temperature exceeds this value,
the action Temperature upper limit exceeded is triggered.