Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 149)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 133
￭ Stop by error
If an error occurs while a determination is running that causes the deter-
mination to be interrupted, then the error track will be run (if present)
and the determination will be ended.
￭ Processing exit track
If the main track and all of the tracks that it has called up are finished,
then the exit track (if present) will be run and the determination finished.
The status switches to READY after the end of the main track.
7 - Conditioning (only for methods with conditioning)
Conditioning is started with the loaded method in the case of methods
which contain commands with switched-on conditioning. The requirement
for this is that the Automatic conditioning option is switched on in the
START command. The conditioning starts immediately after the end of the
track which contains the command with conditions.
￭ Conditioning condition not fulfilled
After conditioning starts, the status switches to COND BUSY. A new
determination can be started in this status with [Start], even though the
conditioning requirement is not fulfilled. Conditioning can also be can-
celed with [Stop] or interrupted with [Hold] and resumed with [Cont].
If an error occurs during conditioning, then neither the error track nor
the exit track will be run through.
￭ Conditioning condition fulfilled
If the conditioning requirement has been fulfilled, then the status will
switch to COND READY. A new determination can be started in this
status with [Start]. Conditioning can however also be canceled with
[Stop] or interrupted with [Hold] and resumed with [Cont]. As long as
the determination has not yet been started, the conditioning requirement
will continue to be monitored on a continuous basis.
3.6.3.9 Single determination - Properties
3.6.3.9.1 Properties - Overview
Dialog window: Workplace ▶ Run ▶ Single determination ▶ Properties Run win-
dow ▶ Properties - Single determination
The properties for the tab Single determination are set on the following
tabs:
￭ Display
Definition of the columns that are to be displayed on the tab Single
determination.
￭ Edit
Definition of sample data which are copied automatically into the next
determination.
￭ Process
Options for the processing of single determinations.