Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1561)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual Control
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1545
[<]
Sets the stepping motor to ACTIVE and moves in negative direction as
long as the button remains pressed or until an end position is reached.
Absolute position
On this tab an absolute position can be moved to.
Port description
Display of the port description.
Port
Display of the internal description of the port.
Type
Display of the port type.
Distance
Distance to be moved to.
Visible only in cases of stepping motors where Type = Linear drive.
Range -214783647 ... 214783647 mm
Default value 0 mm
Angle
The angle to be moved to.
Not visible in cases of stepping motors where Type = Rotary drive.
Range -214783647 ... 214783647 °
Default value 0 °
Timeout
Time in seconds or minutes within which the action must have run through
completely. If this is not done after the maximum waiting time has expired,
the status of the stepping motor will be set to ERROR.
Range 0 ... 999999
Default value 10
Selection s | min
Default value s
Status
Display of the current status.
Selection ACTIVE | INACTIVE | ERROR