Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1301)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1285
￭ 756/831 Coulometer
￭ 712 Conductometer
￭ 856 Conductometer
￭ 867 pH Module
￭ 846 Dosing Interface
￭ 730 Sample Changer
￭ 774 Oven Sample Processor
￭ 778/789 Sample Processor
￭ 814/815 Sample Processor
￭ 855 Robotic Titroprocessor
￭ 864 Balance Sample Processor
￭ 874 Oven Sample Processor
￭ Avantes Spectrometer
￭ RS-232 device
￭ Balance
￭ Barcode reader
￭ IO controller
￭ Stepping motor controller
6.6 Subwindow Titrants/Solutions
6.6.1 Titrants/Solutions - General
Subwindow: Configuration ▶ Titrants/Solutions
Subwindow Titrants/Solutions
The subwindow Titrants/Solutions contains the solution table with all
automatically recognized and manually added titrants and auxiliary solu-
tions. It can be shown in a separate window in the program part Configu-
ration as a part of the Configuration view or (if not present on the desktop)
with View
▶ Quick access. The subwindow can be enlarged and reduced
as required; it can also be maximized.
Titrant
Titrants are used as solutions for the titration commands DET, MET, SET,
KFT and STAT. They can be used in exchange units or dosing units.
Auxiliary solutions
Auxiliary solutions are used as solutions for the dosing commands ADD,
DOS and LQH. They can be used in exchange units or dosing units.
Intelligent exchange units (IEU) and dosing units (IDU)
Intelligent exchange and dosing units have a data chip with stored solution
data. When mounted on intelligent devices (e.g. Titrando) they are recog-
nized automatically and stored in the solution table.