Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 610)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
594 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can be
taken over and saved from existing measuring commands (i.e. MEAS) which
can also be displayed in curves under the designation Extern 1…3 and used
in formulas as variables 'Command name.EX1…3'-
[New]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 880).
[Properties]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 880).
[Delete]
Deletes the external measured value selected in the table.
5.6.3.3.3.9 MET U - Measured value window
Dialog window: Method ▶ MET U ▶ Properties... ▶ Potentiometric evalua-
tion ▶ Evaluation with measured value window ▶ [New]/[Properties] ▶ Measured
value window#
Measured value windows are regions on the measured value axis for which
different parameters for potentiometric evaluation can be defined. Only
those endpoints which lie within these windows and additionally meet the
parameters defined for each window will be recognized. Only one endpoint
will be recognized per window.
Lower limit
Lower limit for the measured value window.
Titrando, 855
Range
-2000.0 ... 2000.0 mV
Default value -2000.0 mV
Titrino
Range
-2000 ... 2000 mV
Default value -2000 mV
Upper limit
Upper limit for the measured value window.