Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 380)

4.8 Subwindow curves ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
364 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
4.8.4 Properties
4.8.4.1 Curve properties - Overview
Dialog window: Database ▶ Curves ▶ Properties curves #
The properties for the display of curves can be set on the following 5 tabs:
￭ x axis
Parameters for the graphical display of the curves on the x axis.
￭ y1 axis
Parameters for the graphical display of the curves on the y1 axis (left-
hand y axis).
￭ y2 axis
Parameters for the graphical display of the curves on the y2 axis (right-
hand y axis).
￭ Options
Options for graphical display of curves.
￭ Measuring point list
Parameters for showing the measuring point list.
4.8.4.2 Curve properties - x axis
Dialog window: Database ▶ Curves ▶ Properties curves # ▶ x axis
Parameters for the graphical display of the curves on the x axis.
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved per
curve window and per client.
Selection DET | MET | SET | MEAS | MEAS T/Flow | MEAS
TC Cond | MEAS Ref | MEAS Opt | MEAS Spec |
CAL Spec | KFT | KFC | BRC | STAT | DOS | TET
Default value DET
Note
When the dialog window is opened, those Command type will be selec-
ted as standard which applies for the curve shown in the curve window.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be
edited.