Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1175)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1159
Appearance
The command has the following appearance:
Parameters
The parameters for the command CTRL are configured in the following
dialog window:
￭ 5.6.9.2.2CTRL - Properties
Command variables
The following command variables are generated in the method run by the
command CTRL and can be used in formulas under the designation 'Com-
mand name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command has
never ended
5.6.9.2.2 CTRL - Properties
Dialog window: Method ▶ CTRL ▶ Properties... ▶ CTRL - 'Command name'
Command name
Name of the command.
Input 25 characters
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.