Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 618)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
602 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the device
type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types or
device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | Titrando
Default value Titrando
Dosing device
Dosing device
Selection of the number of the dosing device (dosing or exchange unit) with
which the solution is to be dosed. All the dosing device connections which
are possible with the selected device type are displayed.
Titrando
Selection
1 | 2 | 3 | 4
Default value 1
855
Selection
1 | 2 | 3
Default value 1
Titrino
Selection
internal D0
736, 751, 799
Selection
internal D0 | external D1 | external D2
Default value internal D0
Solution
Input of a solution name or selection of a solution from the solutions defined
in the solution table. If intelligent exchange or dosing units are used, then
a check will be made in the method sequence to see whether the correct
solution has been set on the selected dosing device and whether the dosing
device type is correct. With non-intelligent exchange or dosing units, only
the cylinder volume is checked. At the start of the command, a check is made
of the working life, the validity of the titer and the GLP test interval for the
selected solution.
Input 24 characters
Selection 'Solution name' | not defined
Default value not defined