Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 881)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 865
Identifica-
tion Description
MA.TIM Time at maximum measured value in s
MA.VOL Volume at maximum measured value in mL
MI.MEA Minimum measured value in the unit of the meas-
ured value
MI.TIM Time at minimum measured value in s
MI.VOL Volume at minimum measured value in mL
NMP Number of measuring points in the measuring
point list
SME Start measured value (measured value after pro-
cessing the start conditions) in the unit of the
measured value
STY Type of stop with which the command was stop-
ped: 1 = normal;0 = manual or after error
SVA Start volume absolute (volume that was added
according to the start condition "start volume") in
mL
TITER Titer value of the solution used for the command
5.6.3.9.2 TET - General/Hardware
Tab: Method ▶ TET ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device, the electrodes and the stirrer are
defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.