Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1297)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1281
Note
The device status is permanently monitored and updated for USB devices
only. For Metrohm devices with RS-232 connection, the current status at
the last access to the device is shown always. For balances, barcode read-
ers and generic RS-232 devices, the status cannot be monitored. It will be
set to ok after confirmation of the connection test.
Start-up
Date on which the device was added to the device table.
Next GLP test
Date on which the next GLP test is due. If GLP monitoring is switched on
and the set date is before the current date (i.e. the GLP test has not yet been
carried out) then the date will be shown in red.
Remarks
Remarks about the device.
Note
Lines that contain red entries will also show the line number with a red
background.
As soon as a determination is started all the devices or device components
used in the method (dosing devices, measuring inputs) will be occupied,
i.e. they can neither be used at a different workplace nor used or config-
ured in manual control until the determination has been terminated. The
line for an occupied device is shown in gray letters.
Table view
The device table cannot be edited directly. With a click on the column title
the table can be sorted according to the selected column in either increasing
or decreasing sequence. The table view can be adapted with the left mouse
button as follows:
￭ Drag the border between column titles:
Sets the column width.
￭ Double-click on the border between column titles:
Sets the optimal column width.
￭ Drag the column title:
Moves the column to the required location.
If the contents of a field is larger than the column width then the whole
contents will be shown as a Tooltip if the mouse cursor is kept on the field.