Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1513)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1497
Assigned output
Selection of an output port assigned to an input port. The signal of the
output port depends on the signal of the input port.
Only active and editable for the port type level detector and leak detector.
Selection
All digital outputs
Note
Digital outputs of the Type = Alarm signal cannot be selected.
Signal
Select which value the signal on the output port should take.
Only active and editable for the port type level detector and leak detector.
Selection
Input signal | Inverted input signal
Default value Input signal
Message
Only active and editable for the Port type = Level detector.
Message by E-mail
on | off (Default value: off)
If this option is enabled, the message is additionally sent to the e-mail
address defined under [E-mail]. The message is sent in text format.
[E-mail]
[E-Mail] opens the Send e-mail window (see Chapter 2.6.1, page 86).
Acoustic signal
on | off (Default value: off)
If this option is enabled, an acoustic signal will be emitted additionally to the
message defined above
Whichever Action has been selected, the corresponding message is also
displayed on the Messages tab of the Live display (see Chapter 3.8.4,
page 173).
If, because of an Action, the message is documented in the determination,
it is displayed in the determination overview on the tab Messages in the
subwindow Information (see Chapter 4.6.6, page 346) and can be put out
in a report.