Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1167)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1151
Note
If no solutions have been defined, then the selection box will be empty.
The creation of solutions is described in the configuration (see Chapter
6.6.1, page 1285).
Save result as global variable
on | off (Default value: off)
The result will be saved under the selected name as global variable if this
option is activated (see Chapter 6.9, page 1341). In all cases, only the single
value for this result will be saved as a global variable, even if the statistics
are enabled for this result.
Global variable
The result is saved as new value for this global variable.
Selection List of all the global variables defined
Note
If no global variables have been defined, then the selection box will be
empty. The creation of global variables is described in the configuration
(see Chapter 6.9, page 1341).
Note
For global variables which are newly calculated during a determination in
a CALC command and which are saved in the configuration, the current
values are available for additional calculations in the same determinations
from this instant. This is not the case for determinations running at the
same time on other workplaces; here, the values available at the start of
the determination are applied.
[Save as template]
Open the dialog window Save result template in order to save the result
parameters as template for the creation of new results (see Chapter
5.6.8.2.6.2, page 1152).