Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 550)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
534 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Titrando, 855
Range
0 ... 999999 s
Selection off
Default value off
Filling rate
Speed with which the dosing cylinder is to be refilled after the titration. The
maximum filling rate depends on the cylinder volume of the exchange unit
or dosing device used.
Titrando, 855
Range
0.01 ... 166.00 mL/min
Selection maximum
Default value maximum
Titrino
Range
0.01 ... 150.00 mL/min
Selection maximum
Default value maximum
5.6.3.2.5.6 DET Upol - Potentiometric evaluation
Tab: Method ▶ DET Upol ▶ Properties... ▶ Potentiometric evaluation
Command name
Name of the command.
Input 25 characters
Parameters for the potentiometric evaluation of the titration curve with
automatic equivalence point recognition. One of the following three evalu-
ation methods can be chosen here:
Potentiometric evaluation
Selection Evaluation without window | Evaluation with
measured value window (Upol) | Evaluation
with volume window (mL)
Default value Evaluation without window
Evaluation without window
With this option set, the two parameters EP criterion and EP recog-
nition will be applied across the entire range of the titration curve.