Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 60)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
44 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Identifica-
tion Description Commands
.SPO Current external position (entry
when ending the command); 0
means invalid position SWING
.STE Start temperature (temperature
after processing of the start condi-
tions) in °C DET, MET, SET,
KFT, KFC, BRC,
STAT
.STY Type of stop with which the com-
mand was stopped: 1 = normal;0
= manual or after error DET, MET, SET,
KFT, STAT,
MEAS, CAL
MEAS, STDADD,
DOS
.SVA Start volume absolute (volume that
was added according to the start
condition "start volume") in mL DET, MET, SET,
KFT, STAT
.SVM Start volume measured value (vol-
ume which was added according to
the start measured value given in
the start conditions) in mL DET, MET
.SVS Start volume slope (volume that
was added according to the start
condition "start slope") in mL DET, MET
.SVT Total start volume (volume that was
added in dependence on all three
start conditions) in mL DET, MET, SET,
KFT, STAT
.TC.TC Temperature coefficient of the con-
ductivity in %/°C MEAS Cond
.TC.C0 Coefficient of the Chebyshev poly-
nomial of conductivity of the zeroth
order MEAS Cond,
MEAS TC Cond
.TC.C1 Coefficient of the Chebyshev poly-
nomial of conductivity of the first
order MEAS Cond,
MEAS TC Cond
.TC.C2 Coefficient of the Chebyshev poly-
nomial of conductivity of the sec-
ond order MEAS Cond,
MEAS TC Cond
.TC.C3 Coefficient of the Chebyshev poly-
nomial of conductivity of the third
order MEAS Cond,
MEAS TC Cond