Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 153)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 137
Selection Always accept data | Accept data only for
active window
Default value Always accept data
Always accept data
If this option is selected, then the data sent from the balance is imported
into all of the Single determination tabs of the open workplaces for
which this balance is defined as data source.
Accept data only for active window
If this option is selected, then the data sent from the balance is imported
only into the Single determination tab of the workplace that is actively
selected.
Confirmation necessary to accept data during the determination.
on | off (Default value: off)
If this option is switched on, then data will not be imported during a deter-
mination except when the Data input dialog of a REQUEST command is
open.
Import from barcode reader
on | off (Default value: off)
If this option is enabled, then external data from the selected barcode reader
will be imported into the fields on the tab Single determination. The
device properties of the barcode reader will define the field into which the
data is imported (see Chapter 7.18.4, page 1475).
Barcode reader
Selection of the barcode reader from which data is to be imported.
Selection Device name
Selection Always accept data | Accept data only for
active window
Default value Always accept data
Always accept data
If this option is selected, then the data sent from the barcode reader is
imported into all of the Single determination tabs of the open work-
places for which this barcode reader is defined as data source.
Accept data only for active window
If this option is selected, then the data sent from the barcode reader is
imported only into the Single determination tab of the workplace that
is actively selected.