Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1519)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1503
Reset
A reset is carried out on the terminal the motor is connected to. While
doing so, the LEDs of the terminal will shortly flash, afterwards it could
be necessary to reference anew.
Distance
Distance to be moved to.
Visible only in cases of stepping motors where Type = Linear drive.
Range -214783647 ... 214783647 mm
Default value 0 mm
Angle
The angle to be moved to.
Not visible in cases of stepping motors where Type = Rotary drive.
Range -214783647 ... 214783647 °
Default value 0 °
Ports assigned
The port information for these ports is automatically read out of the stepping
motor controller.
Reference position
Display of the port description.
Safety switch 1
Display of the port description.
Safety switch 2
Display of the port description.
Safety switch 3
Display of the port description.
Brake
Display of the port description.
Note
The ports assigned and the further properties of the stepping motor (e.g.
speed, acceleration, axis feed, ...) are defined in the program IO Con-
trolCenter.