Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1365)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1349
6.9.3.4 History - Limits
Dialog window: Configuration ▶ Global variable ▶ [Edit] ▶ Properties ▶ Global var-
iable - 'Name' ▶ History ▶ [Limit value] ▶ Limits for Global variable - 'Name'
In the dialog window Limits for global variable both warning and inter-
vention limits can be defined for the values of the global variables. If you
have defined limits then these will be shown in the graph in orange for
warning limits and red for intervention limits. However, whether these limits
are observed is not monitored, i.e. exceeding these limits does not trigger
any action.
Warning limits for global variable
on | off (Default value: off)
If this option is enabled then the values of the global variables will be shown
in orange if these limits are exceeded.
Lower limit
Lower warning limit for global variable.
Range -1.0 E+99 ... 1.0E+99 (max. 10 digits)
Upper limit
Upper warning limit for global variable.
Range -1.0 E+99 ... 1.0E+99 (max. 10 digits)
Intervention limits for global variable
on | off (Default value: off)
If this option is enabled then the values of the global variables will be shown
in red if these limits are exceeded.
Lower limit
Lower warning limit for global variable.
Range -1.0 E+99 ... 1.0E+99 (max. 10 digits)
Upper limit
Upper warning limit for global variable.
Range -1.0 E+99 ... 1.0E+99 (max. 10 digits)