Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1270)

6.3 Configuration data ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1254 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
6.3.3 Templates
6.3.3.1 Template - Custom calibration buffer
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Custom calibration buffer
You can define 5 of your own calibration buffers for pH calibration with
automatic buffer recognition in the dialog window Custom calibration
buffers. This buffer series is globally valid and can be selected as buffer type
Custom in the command CAL LOOP pH. The dialog window consists of 5
identical tabs for the 5 buffers.
Buffer table
The buffer table shows the defined pH values for the calibration buffers in
5°C increments. The table can neither be edited nor sorted.
[Edit]
The dialog window Change pH value opens (see below).
[Delete All]
All the pH values of the selected buffer will be set to off.
Dialog window "Change pH values"
In the dialog window Change pH values you can edit the pH values for
the buffer selected in the buffer table.
Temperature
Selects the temperature for which the pH value is to be edited.
Range 0 ... 95 °C
pH value
pH value of the buffer for the selected temperature.
Range -20.000 ... 20.000
Selection off
Default value off
Note
For your own calibration buffers you should enter the pH values for the
particular temperature range in which your pH calibration and measure-
ments will later be carried out. If you do not know the pH values for
individual temperatures these will be automatically calculated by linear
interpolation.