Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 121)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 105
File type
Prescribed format *.csv.
Selection [*.csv]
Default value [*.csv]
[Save]
The sample data will be written to the export file.
3.3.1.8 Sample table test
Dialog window: Workplace ▶ Sample table / Determination series ▶ [Sample
table] ▶ Sample table test... ▶ Sample table test -Sample table name
The menu item [Sample table] ▶ Sample table test... or the symbol
is used to perform the sample table test. At the same time, the dialog
window Sample table test - 'Sample table name' in which the infor-
mation concerning the test is displayed opens.
Note
The Sample table test is only used to check whether or not all sample
data is correct (in contrast to the Run test (see Chapter 3.6.2, page
122), which also checks the required hardware).
Line
Displays the line number of the currently tested sample data line.
Status displays
One of the following status displays appears underneath the line number:
Selection Sample table test running… | Sample table test
stopped manually | Sample table test finished
without errors | Sample table test finished with
errors
Sample table test running…
This display appears during the test run. A progress bar also appears; the
test can be interrupted thereby by means of the [x] next to the bar.
Sample table test stopped manually
This display appears if the sample table test was canceled manually by
the user.
Sample table test finished without errors
This display appears at the end of a sample table test that has been com-
pleted without errors.