Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 972)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
956 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Titrando, 867
Selection
1 | 2
Default value 1
855
Selection
1
Default value 1
Sensor
Selection of an ISE sensor from the ISE sensors available in the sensor table.
Selection 'Sensor name' | ISE electrode
Default value ISE electrode
Temperature measurement
Type of temperature measurement.
Titrando, 855
Selection
continuous | automatic | off
Default value automatic
continuous
A temperature sensor must be connected. The temperature will then be
measured continuously.
automatic
If a temperature sensor is connected then the temperature will be meas-
ured continuously. Otherwise the temperature entered manually under
Temperature on the Titration parameters tab will used.
off
The temperature will not be measured. The temperature entered man-
ually under Temperature on the Titration parameters tab will be
used.
Stirrer
Stirrer
Selection of the stirrer.
Selection 1 | 2 | 3 | 4 | off
Default value 1
off
Means that no stirrer will be used.
Stirring rate
Setting the stirring rate. The algebraic sign of the stirring rate changes the
direction in which the stirring is done.