Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 935)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 919
Maximum evaluation
Maximum evaluation
on | off (Default value: off)
If this option is enabled, then the associated volume, time and temperature
for the maximum measured value will be interpolated from the measuring
point list.
Threshold value
The evaluation of the maximum begins as soon as the slope of the curve
exceeds the set threshold value.
Range 1.0 ... 2000.0 mV/s
Default value 25.0 mV/s
Break-point evaluation
Break-point evaluation
on | off (Default value: off)
If this option is enabled, then sharp, almost 90° changes in directions in the
measurement curve will be evaluated.
EP criterion
Measure of the minimum sharpness of the break point. The smaller the EP
criterion set, the more break-points will be found. As this is a relative value
related to the total measured value modification, even small changes in the
measured value can be evaluated as a break point for a small measured value
range.
Range 0 ... 1.0
Default value 0.3
Slope
Minimum difference between the slope before and after the break point.
The smaller the difference, the more break-points will be found.
Range 0.0 ... 10.0
Default value 0.9
Smoothing factor
The higher the smoothing factor, the fewer endpoints will be found.
Range 2 ... 20
Default value 5